LISEN 17MM Charging MagSafe Phone Holder

LISEN 17MM Charging MagSafe Phone Holder

The LISEN 17MM Charging MagSafe Phone Holder charges your phone wirelessly at up to 15W, the most you'll get from an OBD-II port, in a compact design with no fan and nothing to hear. It charges fast with minimal heat. It fits our TripleLock, EVO, and NextGen phone mounts and any standard 17mm ball mount, and is tested and supported by OpenSourceEV.

Why This Holder

• Matched to OBD-II Power: Charges at up to 15W, the full wireless rate available from an OBD-II charger.
• Compact and Silent: A slim design with no fan, so there's nothing to hear.
• Subtle Lighting: A near-invisible blue LED ring helps you line up your phone at night without distracting you while driving.
• Almost No Standby Draw: Uses less than 1mW when not charging, so it won't drain your 12V battery.
• Plugs Into USB-A: The included USB-A to USB-C cable plugs straight into a fast-charge USB-A port, like the one on our OBD-II chargers.
• MagSafe Snap-On: Your phone snaps on and off with one hand. No clamps, no plugging in a cable every time you get in.
• Works Without MagSafe: Includes an adhesive magnetic ring for phones or cases without built-in magnets, including most Android phones with wireless charging.
• Fits Our Mounts: Uses a standard 17mm ball joint and fits the TripleLock, EVO, and NextGen phone mounts.

Charging Speed

Wireless charging speed depends on your phone and your power source:

• Up to 15W: MagSafe iPhones and Qi2 phones, from a fast-charge USB-A port like the ones on our OBD-II chargers.
• Android: phones with wireless charging, in a MagSafe-compatible case or with the included ring, charge at their own wireless rate, which on many models is lower than 15W.

What's Included

• LISEN 17MM Charging MagSafe Phone Holder
• Dashboard mount and air vent mount
• USB-A to USB-C cable, 1m (about 40 inches)
• Adhesive magnetic ring for non-MagSafe phones or cases

Power source not included. Plug the included cable into a fast-charge USB-A port:

• R2: the USB-A port on our OBD-II Dual USB Charger.
• R1S / R1T: our Scosche OBD-II to USB-A Quick Charge Connector. Its cord routes the USB-A port up under the steering column, close enough for the included 1m cable to reach your mount.

A basic 5V USB port will charge your phone more slowly.

Technical Specifications

General

Supported Input Profiles (Maximum Ratings)

These are the maximum profiles the holder supports. Actual power draw varies with your phone and its charge level, temperature, and the power source.

Pairs Well With

This holder is available as a Phone Holder option on the mounts below. Choose Lisen Charging MagSafe on the mount's product page to get both together for less than buying them separately.

• TripleLock Phone Mount for R2 -- driver-side vent mount for the Rivian R2
• EVO Phone Mount V4.5 -- inboard mount for the R1S and R1T
• NextGen Phone Mount V2.5 -- driver-side outboard vent mount for the R1S and R1T

For a complete, hidden-wire setup, add the OBD-II Dual USB Charger (R2 and R1 NextGen) or the Scosche OBD-II Connector (R1 Evo).